Thread: [FIXED] Kenmore & Whirlpool Ice Maker LED Blinking Codes

Thank you for your help. I'll let you know how it turns out.
Nelson

Sounds good Nelson.

Jake

Dont worry about the door closed switch at the top of the fridge. I kept on wondering if it was supposed to be taped down to make the thing think that the door was closed etc....(like in normal operation) The test described above is run with the door open(thus the fridge light is on) If you tape the switch at the top of the door shut(light is out) then it just causes the LED to do remain out and makes you think the system is broke(at least i did until i looked at the wiring diagram and noticed the reprecussions) RUN THE LED TEST WITH THE FREEZER DOOR OPEN

clint

What if the led light is not lit at all?

I order the parts, they arrived in 2 days. It took about 5 minutes to install, and it works like a charm. The parts supplier was fast and much cheaper than Sears.

Thanks for all of your help!

Nelson

"Gravity..... It's not just a good idea, it's the law!"

Originally Posted by noleatl

What if the led light is not lit at all?

Then you would need the new P.C. Board assembly listed above.

Jake

Originally Posted by a10acboy

I order the parts, they arrived in 2 days. It took about 5 minutes to install, and it works like a charm. The parts supplier was fast and much cheaper than Sears.

Thanks for all of your help!

Nelson

"Gravity..... It's not just a good idea, it's the law!"

Good job Nelson, glad you got it working again!

Thanks for the update.

Jake

Thanks, I have not yet taken out the icemaker so forgive my ignorance. Where is the PCB located? Is it in the icemaker? Elswhere?

Originally Posted by Jake

Then you would need the new P.C. Board assembly listed above.

Jake

As you open the door on the side-by-side, the PCB receiver is on the side wall with the ice maker lever (left hand on my fridge), the PCB transmitter is on the side that also contains the on/off switch (right hand on my fridge). 3 screws holds the cover on.